Skip to main content

Reply to "My recent PS2 5V board failure"

From the photo, the cap looks ok. Only thing that would melt wires is a short to the metal frame with. Hiigh I draw. I would first find the Nick in the wire insulation and shrink tube over it. I had this happen on Lionel's M7 and MTH SD35 CNJ. Both cases the wheel flange cut into the hot wire on curves. Caps do go bad and puff out at the top. Also, you man notice the yellow chemical on the bottom rubber where the leads are.

 

 

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×