I drilled holes in my Mianne cross braces and installed plastic bushings with a little RTV to hold them in place. The Mianne cross braces are too thick for the bushings to grab with their intended fastening barbs. For running the wire I used the gray two hole plastic conduit straps as shown above by C&O ALLIE. Fastened them to the underside of the table top using only one screw in one hole (a good tip posted here by another forum member). This way you can easily pull them down to add additional wires. Color coded wiring is also highly recommended as is the documenting of the colors used and placing reference lists around everywhere so they are easy to refer to later on. I used OGR wire for all my power, but it is marked with colored electrical tape for each power block. However, I didn't do so good with the reference lists and now have to go back and document which color went where. Never thought I would forget so quickly...
|
|
