Mike CT posted:The red reset button on a TPC400 is top of the unit next to the Run/Program switch. This is a hard wired TMCC device with the wires from the command base attached to the correct terminals. There was a command base cable that was used for this connection. You should be able to daisy chain the TMCC connection from one TPC to another.
Apparently two of you TPC's don't work, may require shop-time for repair or replacement.
I see what looks like a red push button labeled 15 Amp (for the TPC-300) and 20 Amp (for the TPC-400). Pushing them doesn't seem to do anything.
I just went through the whole sequence again of setting the TPC's ID, setting it to Command Mode, and turning power on in Command Mode. I then did a reset to default (full) power - AUX1, AUX2, 0. The light bulb indicator was dimly illuminated. A check (with a voltmeter) indicated 1.1 VAC at the outputs of the TPC.
I think something is definitely wrong with this device.
Any ideas? What do they cost to repair?
George
