I am kind of stumped. First, I finally started to wire the layout I have been building for sometime now. I have two tables pretty much wired. It is set up for Legacy right now but will be adding DCS shortly. Everything has been working that I connected until I wired the track for the Lionel Die Cast lift out bridge. As I run the engine onto the track for the bridge the engine runs to bridge but stops dead going no further. The way I set it up was it starts off with Gar Graves then goes to fast track transition piece, which goes from Fast Track to tubular track then the fast track girder bridge and that is connected to the bridge abutment then the die cast bridge. I also used the Gar Graves transition pins. On The Gar Graves piece of track I have both grounds wired and the power. Have I missed something simple. Any help will be appreciated. Pics. Thanks Paul
