Skip to main content

Reply to "Building a General Models Pacific"

So, I've tried moving the motor forward, and managed to move it a little bit... But not enough. It's sticking out about 1/32 of an inch... So close. I'll try for a bit longer to see if I can get it to move any more forward.

Edit:

I'll add that what I had to do was to tighten the curve of the motor mounting bracket by holding it with a vice and flattening the curve with a hammer. It tightened just enough to move the motor in some.

Last edited by Johnbeere

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×