Skip to main content

Reply to "Need wiring pinout/diagram for 691-ACMC-103 pcb"

4+ years of college, and I couldn't think to flip the board over! Unfortunately, the 6 pin Molex has no markings front or back, other than J1. I assume power and motor wires go into/out of this connector. Is there somewhere else I can find it? Normally I would look up any engine that uses this board and look for a wiring diagram, but I don't know any engines that use this board - any numbers you can offer?

Also J2 (I think that's it, the white 4 pin connector) has a smoke contact. Since this isn't TMCC or anything similar, what's the point of a Smoke connector? Does it turn the smoke on when running and off when in neutral?

As long as I'm asking for the moon, would you happen to know the type of lighting supported, incandescent or LED? Is this the board that provides half wave DC for the lights?

Last edited by GeoPeg
OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
330-757-3020

www.ogaugerr.com
×
×
×
×
×