Skip to main content

Reply to "New Lagacy Polar Express Berkshire Axle Bearing/Plastic found missing when finishing up ballasting"

wmcwood posted:

On the last PE Berkshire run I had a front axle bushing that was not pushed in and seated all the way.  I had to clean the bushing up a  bit so it would actually seat properly.

If I remember correctly there is a slight bump on the bushing that locks it in place when seated.

Just got off the phone with Katie at Lionel.  They are sending me 2 of each (2 without taper and 2 with taper for axle ends).  There parts listing showed both.  I'm confident it is the tapered end since the axle end is tapered.  I will make sure they seat all the way, just in case the 1st one was not.

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×