GF93 posted:Moonman posted:GF93,
Here's my offering. All Ross, the two mountain ends will fit together when the layout is stored as the are on opposite ends. Stacked or leaning. 6 tracks to cut and create electrical connect/disconnect feature for table separation.
A grade won't work properly if a cross-over feature is in the two. It cause one leg of the grade to be two short when using larger than O36/O31 diameter curves. So, I just made an elevated separate line.
Right-click and select save target as to save the SCARM file.
Thanks, Carl!
Interesting. Do you think there would be a way to put a grade from the upper 3rd loop down to the inner bottom loop? Perhaps a curved one that goes under it? Let me see what I can come up with.
Eliminating the ability to cross over between the two lines will permit a grade on the 8' x 8'. The switches pin down the track or are limiting the length of grade.
Here is the O54 & O42 loops with the O52 having a 4% grade by rising to 5". Not high enough to tunnel under.