Good Morning Trainman...I see you added the supports under the roadbed on each end of the gate. I did the same only, I used 2x4s that support the whole gate on each end. Thats why i didn't need the small third caster. As I close the gate it is lifted slightly on both ends. I also put stops on the table ends so the gate can't be pushed out of alignment,this way the gate closes the same all the time. Once you get the track down it as to line up horizontally and vertically. You might want to review my photos again. Of course you might not have any problems at all (looks like you do good work). After I tapered my gate supports I applied a heavy coat of Johnson's paste wax where the wood contacts, that makes a big difference. I can't reach my latch from the inside either, fortunately the gate stays in alignment even when not latched.~ I'm in the process of an expansion, so have to clear everything out to prevent damage and be able to move the whole display two feet.
|
|
