Skip to main content

Reply to "New Layout vs. Old (Build Thread)"

I don't know how to separate the photo's or write under them, I don't have a power off on the swing out I should do that, I had a dead line to meet and just never did it. I have a curved turnout on this gate.  Angle the casters to match your arc.  2x4 on each end of the joining tables set the height they actually lift the table slightly and 1x4 attached to the gate inside edge hinge end line up the table horizontal another 1x4 attached to the table inside edge on the closing end, keeps gate from closing to far.

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×