Hi Pennsy Man,
I'll bet the kids are excited and you, too, when it comes alive. Great project and milestone!
I used another harness, cut in half, with one end attached to a module terminal block, the other wires connected to the power source(s) following the module wiring color specs.
Then, you can just connect the power with the harness connectors.
I also found that a little shot of WD-40 makes the harnesses easier to connect\disconnect.
What did you use or fabricate for leg brackets? Seems to be the main catch.
Thanks for the tip on how to hook up our power source.
As for the brackets, we were lucky enough to have someone able to fabricate them per the drawings in the Fastrack manual. They are working great. We did alter the adjustable feet though went with carriage bolts and t-nuts vice the recommend feet and inserts. Cost was one factor for this change, but the carriage bolt allows us to adjust them from the side with a wrench without having to pick up the module.
Thanks again for the comments!
