Skip to main content

Reply to "New MTH CP Christmas Stage Boxcar Up in Smoke"

@Jon G posted:

These boards have a problem where the solder pads on the voltage regulator are too close together and short.  Usually the LEDs are OK (I just repaired two in the last week); test them with a 9v battery and 220 ohm resistor.  Direct replacement boards are not available, but we use the 6v lighting kit for dummy A-Units, remove the jumpers, cut a trace and move the resistor over from the bad board. Part number AG-0000016.  You must have about 100 ohms between the volt reg output and the connector for the LEDs, or you didn't cut the trace on the board and will burn up the LEDs.

So Jon....I have purchased the 60' streamlined railking passenger cars both the North Pole and the Christmas Express. These look amazing on the track. All seems fine now. Do I need to worry about losing the LED's after my warranty runs out? Are the issues with the boxcars also present in the railking passenger cars? Or are the passenger cars bulletproof?

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×