Thank you, Chris! I hope to get started soon, although to be realistic, it may not be until January. I am going to take the table top off the roll out section I built in the little room, and turn it 90 degrees on the roll out to work for the lower level of the turn around in the upper left. I ordered a benchwork kit from Mianne for the section along the left hand wall. I can do the rest of the benchwork with two more Mianne kits later when funds permit. I decided to go that route after building the roll out, and having a knee that will need replaced in a couple years and back and sciatic nerve problems. Carpentry isn't my specialty, and I decided I should make that part as easy as possible.
I have been thinking of writing some more ideas, but will get to that later.