I opened up the RR file MM, that's great... ty!
Although, I have run into a large road block and one of the reasons why I went elevated in the first place.
This area is my furnace room. What you don't know or see is my electrical panel that is right in the upper left corner.
On paper, its easy to reach, but in reality it is definitely more than a stretch.
Even on my ARTR layout it was a stretch at 36".
Doing the elevated section allowed me to push the outer loop up into that corner putting me at my max reach - a doable 36"
I think I need to do two things 1) Take a look at shortening this layout width wise, down to 8' and then again shortening it by 2' to allow me sufficient walk around room, this will give me a layout dimension of a max 8.5" x 18'
Or 2) Rework the elevated plan again, with the goal of two trains.
