Skip to main content

Reply to "New Train Room Finally Getting A Layout! (Last Update: 07/02/2022)"

George, when I looked at being under the layout and soldering all those wires, not to mention when I have to change a DZ-2500 (already had to remove one), I decided it would be a lot easier to slide a wire into the terminal block and tighten the screw than solder over my head, been there, done that, got the burns to prove it!  They also add the recommended diode protection to the non-derailing leads, something I wasn't aware was needed before.  I went for ease of use and decided to go for it.

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×