Skip to main content

Reply to "No Legacy"

Inspect carefully for cold solder joints on the radio board top, and the joints on the main board. I’ve also breathed life into them with cold solder joints at the two pin antenna connector,…..on one instance, I ran jumper wires from each pin top to the bottom of the main board. Not hard to do, but tedious, and you’ll need really good soldering practices not to make a mess out of it,….that radio board design is pretty awful,….

Pat

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×