Skip to main content

Reply to "No Power/Movement after DCS Startup"

In your photos there are 2-wires (white and yellow) coming from the motor. These 2 wires should go to the last 2 positions of a 10-position tether connector (green connection plate) near the back of the boiler. Then a tether cable goes to the tender. The 2 motor wires re-appear in the tender and go to the 5-position motor connector on the PS2 electronics board. Only 2 of the 5 positions will be occupied. The voltage which drives the motor comes from this connector. My suggestion is to see if this motor drive voltage is present back in the tender - obviously you'll have to open up the tender but I believe it's generally easier to disassemble a tender than a boiler.

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×