Skip to main content

Reply to "No sounds after ERR install"

THe RS and CM are separate, but what can happen is the Serial data may get degraded or corrupted.  YOu have 2 boards in tender besides the mother board.  One is the RS Board the other is the power Supply board for RS.  I would disconnect Serial data from Cruise M.  Also unplug 4 pin molex to prevent engine from moving.  With out serial data you might get full speed.  See if RS functions return.  Also make sure RS/Signal Sound switch in RS position.  If sounds return, the CCM is degrading serial data and you need a buffer.  I assume if this is early 2000 with tether, the unit is RS 4.0.  G

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×