Thx p51. I haven’t worked on this in a couple months. The weather changed along with some relief from the covid lockdowns and I have been very busy with work.
Joe, I snipped off the resistors to feed the leads through the tubing. They were then soldered to the brass ‘conduits’ that are part of the lighting assemblies.
I am actually going to redo some of the lighting to clean it up a bit when I can get myself back in the shop. I ordered some surface mount resistors to solder to the rails which should look a little cleaner. I also got some 40awg magnet wire to use for leads so I can make better conduits.