Skip to main content

Reply to "Northbrook Shops progress (More LED lighting tweaks 9-5)"

I finally got back in the shop for a bit today to experiment with the LED lighting some more. I wanted to swap out the dropping resistors with some SMD ones for a cleaner install. I am running 750ohm 0805s which are good for 100mW heat dissipation but just ordered some 1206s which can go to 1/4 watt. These LEDs are pulling 11mA each so the resistors are at almost 100% heat dissipation. I just wanted to see if I could solder the SMD ones to my lighting  rail. I think it’s a much cleaner look as shown by the comparison photos:

D7D11F05-F43D-4A30-B09F-8F7FEB58E7D7CBFA0479-9843-4FA6-A909-180F4771D702

 

Attachments

Images (2)
  • D7D11F05-F43D-4A30-B09F-8F7FEB58E7D7
  • CBFA0479-9843-4FA6-A909-180F4771D702

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×