John,
What does the hinge mechanism look like for that lift "panel"? As you may not know, I used "dennis" benchwork for mine 
! But, I bet the lifting aspect could be tailored to fit my lift panel. I figured on laying the track out on the hinged section, securing it down, and then cutting the track in strategic places. It all sounds good!
The layout (13' by 32') is split into two halves right above the control panel and on the other end where the lift section will be. On the outer 3 loops, there is a separate 180 watt power brick for each half of each loop - which are mounted on each side of the power center. I wanted conventional control on the inner two loops and the ZW-L gives that option, as well as command control if I choose.
Dennis
