Skip to main content

Reply to "O-22 Switch Operation Using A Z-1000 Transformer"

Disclaimer:  I have no direct experience with the Z-1000 transformer.

From a quick check of the instructions it looks as though the power brick connects to the controller with a special cable.  The other two connectors on the brick must be the 14 volt accessory power.  In a perfect world the two "common" returns (one for the controller, one for accessory power) should be tied together inside the power unit.  If so, all you need to do is to connect the output terminal of the accessory posts to the fixed voltage plug(s).

I'm hoping someone with personal experience of the Z-1000 will check in to confirm or deny, meantime I'm pretty sure this is a "good" answer.

Pete

 

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×