Well I wired in a new smoke regulator....and unless it is by chance faulty, I'm not sure how to proceed.
I resoldered one wire at a time from the old regulator to the new one. All 5 wires were connected on the old regulator so I followed suit on the new one. Both grounds were wired.
I reset (with AUX1 - 2) and tried a new radio board to no avail.
Happening Now : The smoke unit is on all the time and will not respond to commands. It does blow smoke. It comes on immediately when power is applied and can only be shut off with the Smoke on/off switch.
This is early Legacy with modular boards. I have not changed the smoke resistor yet from 6 to 8 OHM.
First 2 pics are the of the old regulator removed....the next 2 pics are of the new regulator wired in. On the "old" regulator the brown wire next to the triac went to the smoke unit. It did not have a black stripe...but the new regulator brown from there did have a black stripe.
Once again ....appreciate the help Guys.
