Basil posted:Awesome smoke rings!
Thanks, I love the effect too.
Engineer-Joe posted:Well?? Was the speaker from the kit? Have you tried a feature reset? It sounds awful quiet? You didn't re-use the 16 ohm stock PS1 speaker did you?
Yes, Kit speaker @ 4 ohms.
There have been a few soundsets released where the volume was lower than others. Later releases had the soundset's volume corrected. Usually you can find a later release and use the sounds.
I will try some others, not enamored with this one for the most part.
I really prefer to use an enhanced speaker like a peerless 4 ohm that will fit. Usually that only helps the low end sounds and not the total volume.
Good to know, what's your source for these?
Hudson J1e posted:Nice job. She runs good, is that Scaletrax you’re using?
Thank you, and yes it's Scaletrax. I love it personally, bends well, looks great, and trains run well on it and the switches.
rtr12 posted:The volume pot is for conventional mode only, doesn't do anything in DCS mode. As for the sound sets, I defer to others with more experience.
That was my understanding too.
Glad to hear the upgrade went so smoothly though, I may try one myself someday.
I had it in my mind as being more complicated, but once I tore into the loco it all went well. The instructions are well done and simple to follow. I read them over twice before starting. I have my GTEL I plan to convert next.