Skip to main content

Reply to "Opening Thomas Remote"

I was able to disassemble my Thomas Remote Control using the above instructions.   Very helpful.  Controller and RF sections of the PC board are apparent. Unfortunately for me, I could not identify any cold solder connections in the RF section.  I could try a heat gun to see if anything pops up.

Also, for the more detailed folks, there is a handy Channel Assignment chart inscribed on the PC board.  So, if you are able to unnsolder/solder surface mount resistors, you could reconfigure a remote control to another channel.  There are 3 channel selections available.

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×