Skip to main content

Reply to "Overheating Bridge Rectifier on TAS SAW Board"

Harmonyards, the engine is regularly run  and the roller p/ups were replaced about a year ago. I removed both motors to check that ground and hot /p/up connections were properly insulating. Grease is fresh.  Its not a mechanical binding issue but thanks.

Gunner, thanks I am going to measure the draw at the rectifier later today.  Not sure where the triac is on the board but will try to check that as well. Is there a way I can test it with a multimeter?

Thank you

Ralph 

 

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×