Skip to main content

Reply to "PBW needed"

The resistor hole spacing on the the Rev. 3A version of the WD board is 6.5mm.  I picked resistors that would fit, typically 1/8w.  Some of the precision 1% resistors of higher power ratings are short enough to work also, just check the datasheet before you order them.

Would there be an issue with mounting a physically "oversized" resistor to the PCB vertically (where the bottom lead goes straight down through the hole and the top lead has a ~180 degree bend to line up with the other hole?  Would this arrangement add unwanted capacitance?

Last edited by SteveH

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×