@Richie C. posted:If the problem is with the roller's conductivity, I like using these soft, minimally abrasive balls in a Dremel to clean and polish them up - available on the big A.
If a pick-up is getting stuck either in the up or down position, perhaps you can insert a tiny, flat-bladed screwdriver in-between where the pick-up rivet fits into the pick-up frame and open up a small enough clearance so it doesn't bind anymore.
Does the pick-up get stuck when you manually press it up and down with your finger ?
@Richie C., thanks for the suggestions. I just ordered the balls... I'm willing to try anything at this point!
As far as the pickup that gets stuck, I just got the specific part # from MTH - I'm wondering, though, if I can pull it off and slightly bend the piece that keeps getting stuck. I'm honestly not sure where it's catching. I will try your suggestion with a screw driver, too.