Skip to main content

Reply to "Powermaster not Receiving Signal from Legacy Base"

Every thing is working now - what happened


1. I traced power to the control board. Every looked good but I noticed one spur on the control board had a power wire to the terminal block for Power District (PD) 3. All the toggle switches should go to PD2. I traced the wire back to toggle switch for spur 1. Ordinarily this would be ok if the switch was isolated from all the other toggle switches except I had connected this switch to all the other switches for PD2. I'm thinking turning on PD2 and PD3 with wires connecting both powermasters must have set up some kind of feed back that upset the powermasters. Once I clipped the wire every thing started working again.  Why it worked for 3 years then stopped working I don't know.

2. As for the powermaster that was 'cooked'. It wasn't. Dum Dum forgot to set the switch from Conv back to Cmd.

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×