Skip to main content

Reply to "Preventing old protosound 2 (5 volt) board from blowing?"

Some of these 5v boards seem to fail even with a fresh fully charged battery.  The weak component seems to be a 330uf  @ 35v capacitor   It can be removed  and replaced without separating the boards. According to GRJ this is a common failure point.  When you do make sure you follow good static discharge prevention protocols and use an ESD safe iron.   Make sure to note the polarity of the cap in the board before you remove it.  I bought a bag of these caps and have replaced it one of my four 5v boards and it's still working .  In the early 2000s there was a virtual pox of bad chinese caps and I would imagine this one of them.                      j

Last edited by JohnActon

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×