I have been emailing Carl and he has been quite helpful and Looking to the Forum for advice...I have four loops, no switches, Loop three is completely elevated. I have a ERR board in my #322 Hudson and it runs great on tracks one and two, had to install a loop of wire for a ground plane tied to the trestles. I have even run a wire from the command base to the far end were the trans is for loop four. I put down a ground plane loop between tracks one and two completely around and is grounded to the water pipe. The engine I am having trouble with is my 48075 EP5, I put the Mighty Mite board in it and it runs good on track one and two, Haven't tested on track three, the elevated. Now here is the strange part, when I connected the .22 caps to the power feeds for the track four, it kills the power on that track. If I jump them out with test clips, power is restored. I ran a loop of ground plane on the outside of loop four but engine just sits there. will run fine in conventional with command base off. I tried about 6 different caps and they all seem to block power from trans to track. I am really at the end of this problem, I have been dealing with it for four days and ready to pull my hair out, but I am sure we have all had that problem before...Am I missing something???????????????????
Marty
