Now I am confused too. What reset chip are you using? (the MTH reset chip 50-1023 ) I assumed from the video you purchased a new operating chip. Yes, I purchased from MTH.
Joe also caught another missed step too.
With the operating chip in the board use the programming button and get to reset state 18. Then press and hold the select button I did this. once I selected reset 18 it went into reset mode on the z4000. I held the select button down (no sounds) but it just went into reset mode and 3 clanks and 3 clinks. I also tried pressing select after I did 18 reset mode and nothing was heard the lights flashed repeatly. so I pressed program button and before it shut down I restarted at 10v sounds for a few seconds than nothing. to get a warbled bell and then a clear bell. I never heard these sounds. Release the select button, press program to come out of program mode. (Voltage drops to zero); then immediately raise the throttle to get the engine moving. Don't let it shut down. This should execute the reset #18. G
