Skip to main content

ProtoCoupler Connection to newer Protosound power board

Replacing  Protosound boards in an F2A that has an original protosound board set, where the motor and power connectors are wires, not 2-pin molex connectors.  Question is this:  The protocoupler wire on the original installation goes from 'coil 1' on the board to the center position on the direction switch.

The new board has a four pin connector (see attached photo).  Pinouts are:  ACG, coil 1, ACG, coil 2.  My question is this - Can I connect one wire from 'coil 1' to the center of the direction switch?  or do the couplers operate in a different manner on the new board versus the original?

Bruce

IMG_6454

Original Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×