John,
It looks like you're following the instructions closely. Here's what they say for my Allegheny:
Is the above what you're doing, including the line I highlighted in yellow? If so, two things:
- Your BCR may be bad or the internal circuit charging the BCR is bad. Also, make sure that you've given it enough time to fully charge, say maybe two minutes, prior to attempting any change of settings. Instead of having enough carry-over power in place to allow it to successfully store the setting, there isn't enough and the engine is forgetting its lock-in-forward programming during that brief fraction of a second where the power is off.
- If you think that the BCR is actually good and not bad, try doing an unlock sequence first, and then immediately after that try the lock-into-forward sequence once again.
Mike
