@Cumberland Valley posted:
My understanding for power up was to stay below 10v to come out of Reset. I followed Ddot's guidance but got the same result. When I try to move, I hear 1 bell, the engine sound fades out while the pumping sound continues. Throttling from 16V to 10v I hear the shush and 1 Clank. At no time are there 3 clanks.
When I had the issue before the shop in Hagerstown said there was nothing wrong and that it ran fine for him. I got it home, paid closer to attention to moving the throttle and after a few attempts it ran. I assumed it was overly sensitive to voltage and ran it some more times before boxing it up until this week.
I assume the Force chip is worth
if you have the chip try it - if that doesn’t work my bet is a loose board connection or cold solder on one of the boards ..I think someone else mentioned that before.
you're welcomed to get in touch over email if you need help/repair