Skip to main content

Reply to "PS-2 used to control TAS Smoke unit"

Put 2 MTH resistors in the smoke unit, in parallel. You can solder them together under the PCB and stick 1 set of leads through the PCB to connect to the PS2 output. You don’t need the thermistor and you can cut the control circuit off. The circuit board just becomes a seal. Just drive it with the PS2 board.  I did this along time ago with an atlas loco that had a TAS unit in it.

Last edited by Boilermaker1

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×