Skip to main content

Reply to "PS-2 used to control TAS Smoke unit"

I do not want to use the protection feature. I was looking at cutting the traces from the resistors back to the board and wire the smoke unit the same as any other PS-2 smoke unit. I stated about the protection circuit so as to verify what unit i was working with. Sorry for not being clear of my intent. My question is can I use the 10ohm resistor that is in the unit or should I get the value down to 8 as is used by MTH? Thank you.

Forest.

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×