Hi good morning john , i recently purchased a mth 20-3044-1 for myself, my question is the boards were bad but it does not look like the standard 5 volt boards, I'm going to install a 3 volt board but one of the connectors that come from the motor and tach harness is larger and has more pins on the socket then other boards. Question can i spice in a tach cable harness on the the leads on the 3 volt board thart normally only has four leads second connector from the left edge and then change the other connector from the motor and then plug in in where it would normally go! thanks for any assistance. theboard i believe is no longer available but the wire colr schemes are the same as the other board!
sincerely thanks for any help you can supply.
I believe it looks like there should not be a issues and work, just wanted to double check with the forum guru's like you and george or marty Originally Posted by gunrunnerjohn:
You can write a custom name to the locomotive from the remote, it'll stay until you do a factory reset on the locomotive. As previously stated, only MTH techs have the service loader that allows a permanent name to be written.
