Skip to main content

Reply to "PW Whistle Detection Circuit"

bmoran4 posted:

Presuming ERR has done all the engineering correctly, their bill of materials should be just fine:

JP1, JP2 2 pin connector 277-1273-ND
RL1 Relay 425-1210-5-ND
T1 Transistor (NPN) 2N3904FS-ND
C1 Cap 0.1uf / 50v radial
C2 Cap 33uf / 35v 6mm diameter, 2.54 mm leads, radial
R1 100k / .25w film resistor
R2 1k / .25w film resistor

The optoisolator is rated for a switched load of 3 amps. You may be able to find other optoisolators in the same family that have a higher switched current that may work for you if needed (but may have a different footprint).

There may be different conversations going on, but in looking at the ERR Hobby Corner page shown below, the above parts list is for the Post War Whistle Controller which does NOT have the DC detector circuit.

err hobby corner

The DC whistle/horn detector circuit (referenced by the OP) is in the Solid State Post War Relay Replacement which has a different parts list.

Attachments

Images (1)
  • err hobby corner
Last edited by stan2004

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×