Skip to main content

Reply to "Question about adding DCS to Lionel setup"

I am basically in the same boat. You say MTH commander are you talking about the remote commander. https://mthtrains.com/50-1033

If so it can be ran in passive mode, run wires from the fastrack spade connections, out to the remote commander output. Don't think you can run two MTH engines separate with this, they would both respond equally on the same track. Also note that the engine must be at the factory reset condition to respond to this remote. There is a key sequence to reset to factory condition.

Oldmike

 

Last edited by OldMike

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×