Modular board TMCC using an R2LC has a list of restore numbers that are used with the R2LC. Any R2LC board needs it's identity to be put in after the AUX-1. The same R2 board can be used for a few different engines. At the back of every engine manual is a section to restore features and it will give the number to be used following AUX-1 then engine number then needed code. Example if the engine is number 10. Slide program switch to program. Then press ENGINE 10 SET. Then ENGINE 10 AUX-1 THEN NUMBER NEEDED. Slide program switch back to run.
If you are doing this with early Legacy using modular boards, the process is the same with the exception of the AUX number. You want to use AUX-1 then 1 for steam and use 2 for diesel.
Moving on to the RCMC (best ever) board. Slide program switch to program then enter engine number then set. Done and over. No more AUX codes needed with the RCMC board.
