Skip to main content

Reply to "Recommendation: Connector / breakout boards for computer power supplies"

@barnun posted:

Hokie71,

From what limited number I've seen, the 4 pin square plug is most likely +12v (x2)  & Grd (x2).  The 6 pin I've not ran across.  Have you considered just putting a volt meter on it?  Also, not sayin' they don't exist, but I'd be very surprised if you can find a prefabricated breakout board for your Dell supply.  Hope this helps.

bd

Good idea on the meter,  I should have paid attention to what they were connected to before I pulled them loose .  Once I know what they are, I might get lucky that they fit a sub set of the 24/20 pin connector.

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×