Skip to main content

Reply to "Removing truck and coupler assembly from Lionel Quad Hopper"

Mark, it looks like I might have done this with an MPC Illinois Terminal quad by snapping out the ends from the hopper body, then drilling out the rivets, and replacing with the sprung trucks and screws, then snapping the end assembly back in. It does look tricky, though. I should mention it looks like they snap out from the sides, and the ends can drop down.

Last edited by Artie-DL&W

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×