Skip to main content

Reprogramming a K-Line Steam Locomotive

I am having trouble getting consistent performance with a K-Line Pennsy K-4.  It is Road Number 1361.  So I have looked at the manual and went through the steps, going from run to Prog. and then back.  I get all the normal responses as in the Whistle Blowing and the ID is set.  But I have read other instructions from the reference material in the section above that GRJ and Marty E have uploaded.  It has a section regarding setting speed steps and assigning features to the locomotive.  Press the bell direction Aux1 and 7,8.  It says that you should perform these functions while in the "RUN" mode.  So my question is, acknowledging having additional locomotives on my layout also in the "RUN" mode, would not all my layout locomotives now be set the same way?

Original Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×