@RickO posted:No. Because you would be addressing the locomotive first. Then entering the commands.
Regardless, any tmcc or legacy locomotive will only respond when addressed by its unique i.d. that you have programmed.
The only exceptions would be if you never reprogrammed anything out of the box as most come as i.d. #1 from the factory. Or in the case of newer legacy.i.d.# 99 is the "all" code.
I am attaching the instruction garnered from the Informational thread that is regarding TMCC/Legacy Reference Material. This document for setting speed steps follows the Manual for this engine in that there is no information/verbiage about "Addressing" thee locomotive. Reading further down the attached file is a dissertation on assigning features and again there is no verbiage regarding "Addressing" the specific Locomotive. Is there since I may not have all the information, How would I garner the attention of the Locomotive I wish to accept the commands? Could you fill in the blanks that I am not understanding for a complete command structure. Is there a response from the Locomotive if the command structure is accepted?
