Skip to main content

Reply to "Reprogramming a K-Line Steam Locomotive"

You may have a bad radio board (R2LC). Try swapping that board between engines and see if the problem follows the board. That could also explain the problem with programming the engines. The R2LC is the one held in place with the 24 pin connector. That just pull off. Make sure when plugging them back in all the pins line up with the mating connector. One column off and the board can be damaged.

Pete

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×