Skip to main content

Reply to "Factory Reset Locomotive that is not in DCS Remote"

Thanks GGG, Just to clarify, here is where I am:

1) I put the loco on a small loop which is connected to the TIU and output #1.  When I turn on the power to  the TIU, the track sees 18-20 volts, signal strength is 10 (per another loco previously used to test) and the "J" sits there- dark- so I am assuming that means the engine is not suspect?

2 )  I don't have any way to recover the engine since I only have DCS wifi and it can't recognize the engine.  Is there a way  to do a recover engine operation?

thanks.

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×