Skip to main content

Reply to "Factory Reset Locomotive that is not in DCS Remote"

GGG posted:

If this is a PS-2 3V, they should swap the Power Supply board.  If that does not fix it, they can try a Sound File reload, but I think the Processor board is bad, at that point your really into a PS-32 repair, since no more processor boards.  Or, run it conventionally.  G

I was a little confused getting down this far into the situation.  The OP stated the engine number and description at the beginning of this thread.    Also pointed out as PS-3.  I looked up the description and cab number on MTH site (30-1601-1 4-8-4 Imperial FEF Northern Steam Engine w/Proto-Sound 3.0)   just to be sure.  No refence to PS2 on this item.  Should only have1 PS3 board unless it has been modified.  I know GGG and others li8sted above as qualified are more than capable of putting this one to bed.  Time to put this beautiful engine with it's DCS features on the layout and have fun.  Not getting any younger.

Greg, is this a PS-3 system or has it been downgraded to PS-2?   If not, probably a bad board.  

Last edited by Bryant Dunivan 111417

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×