Skip to main content

Reverse Unit Hanging Up

I have been repairing a few loco's I picked up to run on my new layout if and when I get to it. I am primarily a tin guy, but will have a loop for S. The reverse units generally seem easy to clean and repair but on a couple of them the plate & catch assembly stays in the up position every 3-6 cycles. A light tap and it drops and we go through the routine again. The assembly appears to be free, I have applied a little teflon to the frame sides to make sure it does not drag on the sides. This helps a little, but not completely. Any suggestions would be greatly appreciated.

 

thanks

 

Steve

Original Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×