Reply to "Revised Two or Four Port TIU Output Signal Indicator Boards Are Ready To Go"

It has come to my attention that there is a bit of a mess up with the resistors listed in my BOM. The PN’s listed in the BOM are actually ½ watt resistors, whereas all that is needed is smaller ¼ watt.

This would not be a big deal, but the ½ watt bodies are 9mm long which is kind of big for the board patterns, though they could be used.

Here are the Digikey PN’s for the more appropriate ¼ watt versions:

They are all in stock at Digikey and costs are $.10 each for qty 1, $.067 each for qty 10, or $.046 each for qty 25. My apologies for this mess up. (I copied the BOM over from a previous project and failed to notice the bigger resistors. My bad.)

I have replaced the original BOM in the OP with a corrected version R1. The revised PN's are highlighted blue.

Rod